5 Takeaways That I Learned About Houses

Decorate Your Home or Office with Crown Moulding Crown moulding is defined as a decorative piece of wood, metal, or plaster that is used to accentuate some places in your home or office. This decorative material can be used either on the exterior or interior of your home or office. Mouldings are installed to frame the walls, ceilings, windows, and door openings of your home or offices. Crown mouldings can add elegance to any room with the decorative design from the wall to ceiling. The importance of a crown moulding is as significant as choosing a frame for an expensive painting. It is important to choose your crown moulding in relation to the design of your home to avoid negative attention. Be wary not to make the crown moulding too big or too small or too simple in comparison to the interior of the room so as not to cheapen the look of the room. Some homeowners would choose crown moulding to suit their personal style, and this shows the importance of this accent piece. It is usually along the seams where the ceiling meets the wall that crown mouldings are installed.
If You Read One Article About Services, Read This One
Your home or office will have an increased value, glamour and beauty if you install crown moulding.
9 Lessons Learned: Homes
It is advisable to take notes of some pointers to follow in order to prepare you in installing the crown moulding. First pointer is to locate all the studs in your walls and ceiling joist. This can be done by making some light pencil marks on the point where you see the moulding up when nailing it. The next step is to find out which way the ceiling joists are running. In a square room, this preparation is important because you have only the nailers for the top of your trim on two of the four walls. The size of your triangle nailer can be found easily by using a framing square. You can still work effectively even if the nailer does not perfectly fit. The next advice is not to have the nailer forcing your moulding not to sit flush against the wall and ceiling by leaving a little room. Your next guideline is the installation of the nailers on the walls without ceiling nailers. You can do this by holding the nailer against the wall and ceiling, then pre-drill the nailer with a counter sink drill bit into the studs on the walls. Next step is to use a 3 inches coarse thread drywall screw in attaching to the stud. Another pointer is putting a reference line on the wall at the height you would want the moulding to sit on the wall. You can do this by taking a piece of scrap moulding, place it against a wall, and then marking it with pencil at the bottom of the moulding.